http://www.begraphic.com/forum/ |
|
| Duplicating a Gauge http://www.begraphic.com/forum/viewtopic.php?f=17&t=155 |
Page 1 of 1 |
| Author: | mattconnolly [ Tue Jun 14, 2011 12:44 am ] |
| Post subject: | Duplicating a Gauge |
I tried to duplicate a Gauge in Excel, using standard copy and paste. After this, BeGraphic Lite had an unhandled exception number too big for a 32-bit int or something, and from that point on I could not edit the properties of either gauge. I had to quit Excel and load it again before I could make a new gauge. Is this supposed to work by using normal copy and paste to duplicate a gauge? |
|
| Author: | BeGraphic Team [ Tue Jun 14, 2011 7:56 am ] |
| Post subject: | Re: Duplicating a Gauge |
Dear BeGraphic user The gauge copy is not allowed in this version of BeGraphic but it will be allowed in the version 2 (in about six month). However it's not normal that you have this error message. Could you please send me your file (by private message or posting a reply to this post). Best regards BeGraphic's team |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|